Pipe Cleaner 1kg

Deposits form over time, especially in the pipes, altering the disinfectant and potentially causing problems during water treatment.

This phenomenon has a negative impact on water quality.

These Pipe Cleaner granules are specially designed for deep cleaning all the pipes in your spa.

Recommendations / Dosage:

Before each time you drain the spa water, use 200g per m³ of Pipe Cleaner in the pre-filter.

Remove the filter cartridge and clean it using SpaTime Filter Cleaner. Then replace the cartridge in the filter housing and activate the filtration system.

Add 200 g of Pipe Cleaner per cubic meter of water to the pre-filter. If your spa is not equipped with a pre-filter, first dissolve 200 g of granules in a container filled with 5 liters of water.

Pour this solution into the spa water.

Run the filtration pump for approximately 5 minutes.

Let it work for about 1 hour, then briefly recirculate the water.

Drain, rinse the spa, and refill it with clean water.

Do not use the spa during the treatment.

If necessary, clean the spa with SpaTime Waterline Cleaner.

Then refill the spa with tap water. Use biocides following safety precautions. Before use, read the product identification and information. In addition to disinfection and pH regulation, spas require occasional maintenance and cleaning to ensure impeccable water quality.

This includes removing deposits from the spa walls and plumbing systems, preventing foam formation after jet activation, and so on.

To help you perfectly clean your spa, SpaTime offers a wide selection of cleaning products specifically designed for spas.